Lead Wire · 10 AWG 600V EPDM Insulation · Electrical Wire and Cable 10EPDM

What this product is for

This product is a 10 AWG EPDM insulated lead wire for 600V electrical applications. It is commonly used for internal wiring in industrial equipment, control panels, motors, transformers, ballasts, coils and solenoids where flexible insulated single conductor wire is required.

Use for

• Control panel wiring
• Internal machine and equipment wiring
• Transformer, ballast and motor leads
• Electrical assemblies requiring 600V lead wire

Avoid for

• Applications requiring a confirmed CSA building wire designation not shown in source data
• Direct burial, wet location or outdoor exposure unless specifically approved by the manufacturer
• Installations where exact temperature class, strand count or jacket colour must be verified before ordering

Best for

Best for electricians, panel shops and OEM buyers needing 10 AWG single conductor lead wire with EPDM rubber insulation and a 600V class rating for internal equipment wiring.

Installed in

Typically installed in control cabinets, machinery, electrical equipment, transformers and similar enclosed electrical systems. This is generally chosen as lead wire rather than branch circuit building wire.

Why this product exists

EPDM insulated lead wire is used where a flexible insulated conductor is needed for equipment wiring and where rubber insulation is preferred for heat resistance and handling. Compared with general purpose building wire, this type is commonly selected for internal leads and factory wiring applications.

Compared with similar products

Compared with PVC hook-up wire, EPDM lead wire is commonly chosen where higher heat resistance is needed. Compared with standard building wire, lead wire is typically intended for internal equipment wiring rather than open building runs. As a rule of thumb, wire gauge should still be matched to circuit ampacity and termination requirements, and actual performance depends on installation conditions, insulation, layout and local electrical code.

Specifications

• Product type: EPDM insulated lead wire
• Wire size: 10 AWG
• Voltage rating: 600V
• Insulation material: EPDM rubber
• Conductor: Not confirmed for this exact SKU from source data
• Temperature rating: Not confirmed for this exact SKU from source data
• Application: Internal equipment and electrical lead wire use
• Approximate conductor diameter for 10 AWG: 0.102 in (2.6 mm), typical AWG reference only