Pull Elbow Emt to Emt · 1/2Inch EMT or Rigid 90 Degree Pull Elbow · .5EMT90P

What this product is for

This 1/2 in EMT to EMT pull elbow is used to join two EMT conduit runs at a 90 deg change of direction while keeping access for conductor pulling. It is commonly selected where a standard bend would make pulling more difficult or where space is limited.

Use for

Use for 1/2 in EMT conduit runs in commercial, industrial, and residential installations, especially at corners, equipment entries, and other tight routing points. The removable cover helps when pulling or feeding conductors through the turn.

Avoid for

Avoid using this fitting where a listed raintight or wet-location fitting is required unless the exact product listing confirms that rating. Also avoid mismatching it with conduit types other than EMT to EMT.

Best for

Best for electricians who need a compact 90 deg EMT fitting with pull access and set-screw style termination. It suits service work, tenant fit-ups, and conduit runs where wire pulling access matters.

Installed in

Typically installed in exposed EMT systems in shops, utility rooms, commercial interiors, light industrial spaces, and similar dry-location applications.

Why this product exists

A pull elbow provides access at the turn so conductors can be pulled more easily than through a closed elbow. This can help reduce installation difficulty in short-radius direction changes and confined spaces.

Compared with similar products

Compared with a standard EMT elbow, a pull elbow adds a removable cover for conductor access. Compared with larger conduit bodies, it is a more compact option for a simple 90 deg EMT-to-EMT change of direction. As a typical trade rule of thumb, conduit fill should remain within code limits, commonly up to 40 percent depending on conductor type and installation. Actual conductor count depends on code, insulation, and layout.

Specifications

• Trade size: 1/2 in
• Metric equivalent: approximately 16 mm trade size
• Conduit type: EMT to EMT
• Angle: 90 deg
• Material: zinc die-cast
• Connection style: set screw, based on matching market listings for this product type
• Cover: removable cover for wire pulling access
• Application: typically dry locations
• Standards seen on comparable listings: commonly UL 514B and NEMA FB-1

Note: Some details above are based on closely matching 1/2 in EMT pull elbow market listings because the exact manufacturer for SKU .5EMT90P was not clearly identified. Manual review is recommended if brand-specific certification or dimensions are required.