EMT conduit elbow · 1/2 inch 90 deg steel elbow · .5EMT90

What this product is for

This 1/2 in EMT 90 deg conduit elbow is used to change direction in an EMT raceway system with a factory-formed bend. It helps electricians route conductors neatly around corners and into planned conduit layouts.

Use for

Use for 1/2 in EMT conduit runs in exposed electrical installations, service spaces, utility areas, and light commercial or industrial raceway work where a 90 deg change in direction is required.

Avoid for

Avoid for conduit types other than EMT unless the fitting is specifically listed for that raceway. Do not assume this elbow includes couplings or pull-access features unless confirmed by the final supplier listing.

Best for

Best for electricians who want a consistent factory elbow instead of field-bending 1/2 in EMT on site. It can also help where layout space is tight or where a clean, repeatable bend is preferred.

Installed in

Typically installed in residential, commercial, and industrial EMT systems in dry locations or other environments suitable for EMT and the installed fittings, subject to local code and project requirements.

Why this product exists

A preformed 90 deg elbow saves bending time and helps maintain a uniform raceway path. As typical conduit guidance, total bend in a run should be planned carefully to support easier conductor pulling. Actual installation limits depend on conductor size, raceway layout, and local electrical code.

Compared with similar products

Compared with a field-bent section of EMT, a factory elbow offers a fixed bend and consistent appearance. Compared with a pull elbow, this style is generally for directional change only and may not provide access for pulling conductors.

Specifications

• Trade size: 1/2 in
• Metric equivalent: approximately 16 mm trade size
• Raceway type: EMT
• Angle: 90 deg
• Material: steel
• Application: directional change in EMT conduit runs
• Part number: .5EMT90
• Brand: Generic or supplier-specific listing to be confirmed