DC Gearmotor · 90V DC 93 RPM Parallel Shaft TENV - Dayton 1LPW5

What this product is for

This DC gearmotor is used to reduce motor speed and increase output torque in compact equipment where the motor and gearbox shafts remain parallel. It is suited to OEM machinery, feeders, conveyors, actuators, and other light-duty motion applications that use a 90V DC drive system.

Use for

Use for equipment requiring approximately 93 RPM output, 13 in-lb maximum torque, and a parallel shaft layout. Commonly selected where space is limited, all-angle mounting is needed, and a TENV enclosure is preferred to help limit exposure to dust and debris.

Avoid for

Avoid for applications requiring reversible shaft output, encoder feedback, high overhung loads beyond 50 lb, or washdown duty. It is also not the right choice where AC power input is required without a suitable DC power supply or controller.

Best for

Best for compact industrial and commercial assemblies that need fixed gear reduction, steady low-speed output, and a parallel shaft arrangement. Typical buying considerations are available DC voltage, required output RPM, shaft orientation, and allowable load on the output shaft.

Installed in

Typically installed in small machinery, packaging equipment, indexing devices, material handling assemblies, and custom automation panels. The all-angle mounting design can help when the motor must fit into tight mechanical layouts.

Why this product exists

This product combines a DC motor and gearbox to deliver lower output speed than the motor alone while increasing usable torque at the shaft. Compared with using a standalone motor and separate reduction components, a gearmotor can simplify mounting and reduce package size.

Compared with similar products

Compared with inline gearmotors, a parallel shaft design can fit better in compact side-by-side layouts. Compared with open dripproof motors, the TENV enclosure is better suited to dirtier indoor environments. As a rule of thumb, gearmotors like this are commonly chosen when controlled low-speed output matters more than high free-running motor speed. Actual performance depends on load, controller settings, duty cycle, and installation conditions.

Specifications

• Brand: Dayton
• Manufacturer part number: 1LPW5
• Product type: DC gearmotor
• Shaft orientation: Parallel
• Input voltage: 90V DC
• Enclosure: TENV (totally enclosed non-ventilated)
• Output speed: 93 RPM
• Maximum torque: 13 in-lb (approximately 1.5 N-m)
• Input horsepower: 1/30 hp
• Gear ratio: 32:1
• Shaft type: Single
• Rear shaft encoder or pulse generator mounting: No
• Mounting position: All angle
• Length less shaft: 5-5/8 in (approximately 143 mm)
• Reversible shaft output: No
• Maximum overhung load: 50 lb (approximately 22.7 kg)