Plastic Wall Plug Anchor · suits #10-12 screws - drill bit included - 10-12PBWALLPLUG

What this product is for

This plastic wall plug is used to create a mechanical fixing point in masonry or other solid wall materials for screws in the #10-12 range. It is commonly used by electricians and contractors when mounting boxes, clips, saddles, brackets, and other light-duty electrical accessories.

Use for

Use for brick, block, concrete, and similar solid substrates where a plastic expansion plug is appropriate. The included drill bit helps match the plug to the intended hole size for more consistent installation.

Avoid for

Avoid using this product where the base material is unknown, weak, crumbling, hollow, or subject to heavy structural loads unless the application has been properly verified. For drywall-only installations or heavier suspended loads, use an anchor designed specifically for that wall type and load condition.

Best for

Best for everyday electrical mounting work where a simple expansion fixing is needed for #10-12 screws. Typical trade use includes mounting light brackets, clips, and surface accessories to masonry.

Installed in

Typically installed in drilled holes in masonry walls. As a rule of thumb, the hole should match the supplied bit size and be drilled slightly deeper than the plug length to allow proper seating. Actual fit depends on wall condition and drill accuracy.

Why this product exists

This product provides a straightforward way to fasten screws into solid wall materials that cannot hold a screw directly. The plug expands as the screw is driven, helping create holding force in the drilled hole.

Compared with similar products

Compared with a bare screw in masonry, a wall plug provides a more secure fixing. Compared with specialty hollow-wall anchors, this type is better suited to solid materials. Based on common market listings for #10-12 wall plugs, this size is typically used with medium-duty electrical and general mounting tasks rather than heavy structural fastening.

Specifications

• Product type: Plastic wall plug
• Part number: 10-12PBWALLPLUG
• Compatible screw size: #10-12
• Included accessory: Matching drill bit
• Typical base materials: Masonry, brick, block, concrete, and similar solid materials
• Application: Light-duty to medium-duty mounting, depending on substrate and installation
• Colour: Not verified
• Plug length and drill diameter: Not verified from manufacturer source

Installation guidance is typical only. Actual performance depends on substrate condition, embedment, screw selection, hole accuracy, and local electrical code.