10/3 NMD90 · Loomex Residential Building Wire · 150M Reel

What this product is for

This 10/3 NMD90 copper building cable is used for indoor residential and light commercial wiring in dry locations. It provides three insulated 10 AWG solid copper conductors plus a bare bonding conductor in a non-metallic sheath for 300 V branch circuit applications.

Use for

Use for indoor branch circuit wiring, renovation work, new construction, and feeder or appliance runs where 10/3 copper with bond is specified. The 150 m (492 ft) reel suits longer pulls and multi-room rough-in work.

Avoid for

Do not use in wet locations, direct burial, or outdoor exposure unless the installation method and cable type are specifically approved for that environment. Confirm code requirements before using in conduit, concealed spaces, or specialty applications.

Best for

Best for electricians and contractors needing Canadian NMD90 cable for indoor dry-location wiring with clear orange jacket identification. It is a practical choice where 10 AWG copper is needed for higher-load branch circuits.

Installed in

Typically installed in houses, apartments, condos, and light commercial interiors in wall cavities, floor systems, and ceiling spaces permitted for NMD90 cable. Actual installation must follow the Canadian Electrical Code and local inspection requirements.

Why this product exists

This cable gives installers a CSA-approved indoor wiring option that combines solid copper conductors, 90 deg C insulation, and a non-metallic jacket in a ready-to-pull 150 m reel. The orange jacket helps identify 10 AWG cable during rough-in and service work.

Compared with similar products

Compared with 12/2 or 14/2 NMD90, this 10/3 cable adds an extra insulated conductor and larger wire size for applications that need more current capacity or multi-conductor branch wiring. As typical trade guidance, 10 AWG copper is commonly associated with 30 A circuits, but actual allowable load depends on equipment rating, termination temperature limits, installation conditions, and local code.

Specifications

• Cable type: NMD90 non-metallic sheathed building cable
• Brand: Nexans
• Manufacturer part number: 12000011
• Size: 10/3 AWG
• Conductors: 3 insulated solid copper conductors plus bare bonding wire
• Conductor material: Copper
• Conductor stranding: Solid
• Bond wire size: 12 AWG
• Voltage rating: 300 V
• Maximum conductor temperature: 90 deg C
• Minimum installation temperature: -25 deg C
• Jacket colour: Orange
• Length: 150 m (492 ft)
• Approximate cable diameter: 10.9 mm (0.43 in)
• Approximate net weight: 227 kg/km
• Insulation: R90 XLPE conductor insulation
• Jacket: Moisture-resistant and flame-retardant PVC jacket
• Flame rating: FT1
• Approval: CSA approved
• Application: Dry locations
• Manufactured in: Fergus, Ontario

Typical buying guidance only: 10 AWG copper branch wiring is commonly used on 30 A circuits. Actual performance depends on installation conditions, equipment terminations, insulation, layout, and local electrical code.