10 RW90 Copper · 600 V XLPE Insulation · White Solid

What this product is for

This product is a single-conductor RW90 copper building wire roll for pulling in conduit and raceway systems in residential, commercial, and industrial electrical installations in Canada. It is commonly selected where a 600V insulated conductor with RW90 XLPE insulation is required.

Use for

Use for branch circuits, feeders, control runs, and equipment wiring in raceways, including dry or wet locations where RW90 conductors are permitted. A 300 m roll is suited to larger rough-in work, service stock, or repeated pulls on site.

Avoid for

Avoid using this wire where a multi-conductor cable assembly is required, where direct burial cable is needed, or where exposed flexible cord is specified. Confirm colour coding, conductor type, and installation method before ordering.

Best for

Best for electricians and contractors needing #10 AWG copper RW90 in a bulk roll for conduit work. White insulation is typically chosen where conductor identification matters, but final colour use should follow the Canadian Electrical Code and project requirements.

Installed in

Typically installed in conduit, raceways, and similar wiring methods in homes, commercial units, and light industrial spaces. 300 m is approximately 984 ft, which helps when estimating longer pulls and reducing partial-roll handling.

Why this product exists

RW90 wire is used when installers need a single insulated conductor rather than a jacketed cable. The XLPE insulation supports 600V applications and is commonly specified for raceway wiring in Canadian construction.

Compared with similar products

Compared with NMD90 cable, RW90 is a single conductor intended for conduit or raceway systems rather than a finished cable assembly. Compared with smaller conductors such as #12 AWG, #10 AWG is typically selected for higher-load circuits such as 30A applications where permitted. This is typical guidance only; actual conductor sizing depends on code, ambient temperature, conduit fill, and termination ratings.

Specifications

• Product type: RW90 copper building wire roll
• Conductor size: #10 AWG
• Conductor material: Copper
• Insulation type: XLPE
• Voltage rating: 600V
• Length: 300 m (approximately 984 ft)
• Colour: White
• Application: Raceway and conduit wiring
• Location rating: Dry or wet locations
• Temperature rating: RW90 insulation type

Buying note: Typical published RW90 data for #10 copper shows approximately 30A in conduit and 40A in free air, but final allowable ampacity must be based on the applicable code table, installation method, ambient conditions, and equipment termination limits.