Rigid Conduit Nipple · 2 in x 6 in - Threaded Steel - 2X6RIGID

What this product is for

This 2 in x 6 in rigid conduit nipple is used to create a short threaded connection between rigid metal conduit or IMC and electrical enclosures, pull boxes, or fittings.

Use for

Use for short raceway connections, panel-to-gutter transitions, enclosure entries, and other threaded conduit layouts where a factory-threaded nipple is preferred.

Avoid for

Avoid where the installation requires a specific material such as aluminium, stainless steel, or PVC-coated steel unless that material is confirmed. Do not assume this item is suitable for corrosive or wet locations without verifying the exact finish and certification.

Best for

Best for electricians and contractors needing a 2 in trade size threaded nipple with a 6 in length for rigid conduit or IMC connections in commercial and industrial work.

Installed in

Commonly installed in service rooms, mechanical rooms, industrial facilities, commercial buildings, and equipment connections using threaded metal raceway systems.

Why this product exists

It provides a simple way to bridge a short distance with threaded conduit while maintaining alignment and mechanical continuity between fittings or enclosures.

Compared with similar products

Compared with full conduit lengths, a rigid nipple is used for short runs and close-coupled connections. Compared with chase nipples, this style is typically selected when a rigid threaded raceway connection is required. Typical conduit fill guidance still applies; actual conductor count depends on conductor type, insulation, and local code.

Specifications

• Product type: Rigid conduit nipple
• Trade size: 2 in
• Length: 6 in (approximately 152 mm)
• Connection type: Threaded
• Compatible raceway: Typically rigid metal conduit and IMC
• Material: Not confirmed from SKU alone
• Finish: Not confirmed from SKU alone
• Brand: Generic / unconfirmed
• Part number: 2X6RIGID

Buying note: 2 in trade size nipples are commonly used where larger conductor bundles or feeder transitions need a short threaded raceway section. Actual suitability depends on conductor fill, bonding method, environment, and local electrical code.