Rigid conduit close nipple · 3/4 in trade size threaded steel galvanized · 3/4XCLOSE

What this product is for

This 3/4 in trade size close nipple is used to join threaded rigid metal conduit or IMC fittings when you need the shortest practical threaded connection. It is typically selected for panel entries, enclosure connections, and tight raceway offsets.

Use for

Use for threaded rigid conduit runs, meter and service equipment, junction boxes, pull boxes, and industrial or commercial raceway work where a short male-to-male connection is required. Typical listings indicate male NPT threads on both ends.

Avoid for

Avoid using this item where a longer nipple is needed for locknut spacing, bonding bushings, sealing fittings, or clearance through thicker walls. Do not assume compatibility with EMT set-screw or compression systems.

Best for

Best for electricians needing a compact threaded raceway connection in rigid or IMC systems. A close nipple is commonly chosen when standard nipple lengths would project too far into an enclosure or fitting.

Installed in

Typically installed in commercial, industrial, and utility raceway systems, including switchgear, panels, wireways, and outdoor threaded conduit assemblies. Where practical, allow room for locknuts, bushings, and conductor bending space.

Why this product exists

It provides a very short threaded connection between two female threaded entries without field-cutting and threading conduit. This helps save labour on small transitions and tight enclosure work.

Compared with similar products

Compared with standard-length conduit nipples, a close nipple minimizes projection and is better for tight spaces. Compared with PVC-coated or aluminium versions, the common market version for this SKU appears to be plain or galvanized steel, but actual finish and manufacturer are not consistently identified online. Verify brand, coating, and approvals if the project specification is strict.

Specifications

• Product type: Rigid conduit close nipple
• Trade size: 3/4 in
• Approximate overall length: 1-3/8 in (35 mm) on common close-nipple listings
• Connection type: Male threaded x male threaded
• Thread type: Typically NPT, based on distributor listings
• Material: Steel on the most relevant electrical distributor results reviewed
• Finish: Commonly galvanized or similar corrosion-resistant steel finish, depending on manufacturer
• Use with: Rigid metal conduit and often IMC where threaded compatibility is required
• Standards: Some comparable listings show UL and CSA approvals, but exact approvals for SKU 3/4XCLOSE were not confirmed to one manufacturer listing

Typical trade guidance: use close nipples when you need the shortest threaded join between two female hubs or fittings. Actual fit, finish, and approvals depend on manufacturer, installation conditions, and local electrical code.